Fourier MicroLog Operation & User’s Manual

76, Chapter 1 MicroLog 76 To restore default calibration, click Default. 6. Defining a custom sensor You can use MicroLog with any sensor that has a 0 – 20mA current output or a 0 – 10V voltage output. a. Click the Logger menu and then select Define new sensors to open the Define New …

163, The Cradle Chapter 3 163 To set up MicroLog (see Figure 6 above): 1. Mount MicroLog onto the cradle (1). 2. Connect the cradle to the PC using either serial or USB communication cable (2). 3. Run your MicroLog’s software and use the setup command. To prepare the wirele…

52, Chapter 1 MicroLog 52 d. Default zooming If you usually need to view a specific time frame (i.e. workday hours) use the Default zooming tool. You can set the start and end time of the time span and then use it whenever you open a file or download data from the MicroLog. To se…

177, External Magnet Antenna Chapter 5 177 1. Open the receiver case, by releasing the four screws on the receiver back 2. Remove the wipe antenna from the screw terminal 3. Connect the antenna hot wire to the right terminal of J1 (wipe antenna location) 4. Connect the…

50, Fourier MicroLog Chapter 1 MicroLog 50 6. Zooming and Panning a. Zooming Click Zoom in on the graph toolbar and drag the cursor diagonally to select the area you want to magnify. Release the mouse button to zoom in to the selected area. Click on the Zoom in button a second time to turn of…

73, MicroLog Chapter 1 73 f. Click Default to restore the original values g. Disconnect MicroLog from the PC and insert it into the …