Foxconn P4M8907SA Operation & User’s Manual

55, Foxconn P4M8907SA Chapter 3 BIOS Description 47 Load Optimized Defaults Load Fail-Safe Defaults Press <Enter> to select this option. A dialogue box will pop up that allows you to load the default BIOS settings. Select <Y> and then press <Enter> to load the defaults. Select <N&g…

17, Chapter 2 Installation Instructions 10 Memory This motherboard includes two 240-pin slots for DDR2. You must install at least one memory module to ensure normal operation. Installation of DDR2 Memory 1.There is only one gap near the center of the DIMM slot, and the memory module can be fi…

59, Chapter 4 Driver CD Introduction 51 Installing Drivers There are two ways to install driver: manual and auto. Click the drivers that you want to install and begin the setup steps by manual. Or you just chick “one click Setup” button to install the drivers by auto after installing …

4, Product Introduction Main Features.............................................................................................2 Motherboard Layout...................................................................................4 Rear Panel Connectors...................................…

68, Chapter 5 Directions for Bundled Software 60 1.2 Local Update - Backup This page lets you backup your system BIOS. Click “Backup”, then give a name. Click “Save” to finish the backup operation. Key in a BIOS name Click here 1.3 Local Update - Update This page lets you update your system…

35, Chapter 3 BIOS Description 27 vPrecharge to Active (Trp) This option controls the number of cycles for Row Address Strobe (RAS) to be allowed to precharge. If insufficient time is allowed for the RAS to accumulate its charge before DRAM refresh, refresh may be incomplete and DRAM may fail …