Tripp Lite SNMPWEBCARD Manual 

Complete Manual & Quick Start Guide
Internal UPS Web Management Adapter Card
Model: SNMPWEBCARD
1111 W. 35th Street,  Chicago, IL 60609 USA
Customer Support: (773) 869-1234  • www.tripplite.com
1) Connecting SNMPWEBCARD to UPS
a. Turn the UPS on.
b. Unscrew and remove the accessory slot cover plate on the back of the 
UPS.
c. Slide the SNMPWEBCARD into the accessory slot. Using an Ethernet 
cable, connect the SNMPWEBCARD to the LAN. The SNMPWEB
CARD by  default is configured for DHCP and will automatically 
obtain an IP address provided there is a DHCP server.
d. Proceed to Step 6b. (Only follow Steps 2-5 if the SNMPWEBCARD 
did NOT automatically receive an IP address when you performed 
Step 1 above.)
2) Manually Configuring SNMPWEBCARD
a. Disconnect Ethernet cable and remove the SNMPWEBCARD 
from the accessory slot.
b. Set the SNMPWEBCARD's jumpers. For most Tripp Lite UPS models, 
set to jumper position 1 (see Fig.1). This is the card's default position. 
For models listed below with their corresponding series 
numbers, set to jumper position 2 (see Fig. 2). 
Note: Series numbers can be found on the back of the UPS.
3) Preparing Computer for Terminal Mode Configuration
a. Open a VT-100-compatible terminal emulation program on your 
computer.
b. Configure the terminal emulation program to use the COM port on your 
computer that will connect to the SNMPWEBCARD, and to use the 
following settings:
Baud Rate: 9600 Stop Bit: 1
Data: 8 bits Flow Control: none
Parity: none
4) Installing SNMPWEBCARD in UPS
a. Unscrew and remove the accessory slot cover plate on the back of the UPS.
b. Slide the SNMPWEBCARD into the accessory slot.
c. Using the cable (73-1025) provided, connect the serial interface 
connector to the COM port of the computer. Then connect the mini din 
8 (circular) connector to the middle port of the SNMPWEBCARD. 
Note: To prevent damage to the connector, make sure that the pins are 
properly aligned.
d. Using an Ethernet cable, connect the SNMPWEBCARD to the LAN.
5) Configuring SNMPWEBCARD in Terminal Mode
a. When the configuration main menu appears on your computer screen, 
you will be prompted to accept or modify current setting. Type M (modify).
b. A password prompt will appear. Type the default terminal password:
TrippLite.
c. Reset Configuration to default values (Y/N) will appear. Type N (no) and 
press ENTER.
d. Network Interface Parameters will appear. You will be prompted with 
Should target obtain IP settings from the network? Type N (no) and 
configure the card to your networks subnets. If you do not know what IP
address to give the SNMPWEBCARD, contact your system administrator.
e. Save settings. The card will then reboot; depending on the selected 
configuration settings, it will take 2-5 minutes for the card to become 
initialized.
6) Preparing SNMPWEBCARD for Operation
a. Remove the cable connecting the SNMPWEBCARD to the computer.
b. Test network configuration by pinging the IP address given to the 
SNMPWEBCARD.
c. If test is successful, replace the UPS accessory slot plate and secure it 
with screws to hold the SNMPWEBCARD firmly in position.
7) Connecting to the SNMPWEBCARD Using a Web Browser
a. Open a web browser on any computer on the LAN.
b. Enter the IP address that was assigned to the SNMPWEBCARD. You 
will be prompted to enter a username and password. Enter the default 
username: admin. Leave the password field blank.
c. The UPS status screen will appear. Additional configurations may be 
specified from this screen: email, SNMP, shutdown parameters and more.
PLEASE READ CAREFULLY BEFORE INSTALLING SNMPWEBCARD 
SNMP: The RFC1628.mib and Tripplite.mib
(provided on the accompanying CD) must be
loaded into every management station that will
monitor the UPS via SNMP.
Documentation: The full SNMPWEBCARD
User's Guide is provided on the accompanying
CD. The User's Guide may also be accessed on
line at www.tripplite.com
Support: If you have any questions or prob-
lems, contact a Tripp Lite Network Product
Specialist at (773) 869-1599, between the hours of
8:30 AM and 5:00 PM CST.
200503171  93-2253

2
4

13
U5
Link Positions
2

4
1

3
Jumper Position 2
U5
Link Positions
Fig. 1
Fig. 2
Tripp Lite 
UPS System Model Series Number
SMART1400RM2U AGSM1400Y2U29
SMART1500RM2U AGSM1400Y2U29
SMART1500RMXL2U AGSM1400Y2U29
SMART2200RM2U AGSM2200Y2U29
SMART2200RMXL2U AGSM2200Y2U29
SM2200RM2U-L520 AGSM2200Y2U29
Tripp Lite 
UPS System Model Series Number
SM2000RMX3U AGSM2200Y2U29
SMART2600RM2U AGSM3000Y2U29
SMART3000RM2U AGSM3000Y2U29
SMART3000RMXL2U AGSM3000Y2U29
SMART3000RM2U AGSM3000Y2U29
This product designed and engineered in the U.S.A.
WARRANTY
REGISTRATION
Register on-line today for a 
chance to win a FREE Tripp Lite 
product! www.tripplite.com/warranty
Jumper Position 1
(Default)
Link Color Link Indicator
Off No Network
Flashing Amber 100 Mbs Network Connection
Flashing Green 10 Mbs Network Connection
Status Color Status Indicator
Off Not Initialized
Steady Green Initialized & Operational
Flashing Amber Error-Not Initialized
Link Status
200503171 93-2253 SNMP Webcard QSG.qxd  8/15/2005  10:06 AM  Page 1

• 
  Zanussi 102294

  Zanussi Refrigerator Manual (#5Y8BF6)

  102294, 2, zanussi/102294.pdf

• 
  Maxi-Cosi PEARL

  Maxi-Cosi Guide: PEARL (#8W52VC)

  PEARL, 16, maxi-cosi/pearl.pdf

• 
  Toshiba RAS-22N3KV2-A

  Air Conditioner RAS-22N3KV2-A Instruction, #6ZMZ1Z

  RAS-22N3KV2-A, 109, toshiba/ras-22n3kv2-a.pdf

• 
  AudioSource AE5C

  AudioSource Reference Book Speakers AE5C (#NQP2MA)

  AE5C, 4, audiosource/ae5c.pdf

• 
  Trane Tracer VV550

  Tracer VV550 Remote Control - #MQ283L

  Tracer VV550, 12, trane/tracer-vv550.pdf

• 
  Bissell 8931 SERIES

  Bissell Vacuum Cleaner Manual (#WCBN97)

  8931 SERIES, 8, bissell/8931-series.pdf

• 
  Kawasaki KBL35B

  #6INID5: KBL35B Instruction

  KBL35B, 1, kawasaki/kbl35b.pdf

• 
  ViewSonic VE155 - 15" LCD Monitor

  ViewSonic Guidance Monitor VE155 - 15" LCD Monitor (#8797AT)

  VE155 - 15" LCD Monitor, 2, viewsonic/ve155-15-lcd-monitor.pdf

• 
  Panasonic KX-TG2650ALN

  Panasonic Tutorial: KX-TG2650ALN (#E535JF)

  KX-TG2650ALN, 64, panasonic/kx-tg2650aln.pdf

• 
  JVC SP-THD5S

  Home Theater System SP-THD5S Guidance, #397E65

  SP-THD5S, 43, jvc/sp-thd5s.pdf

• Search YouTube Videos for Tripp Lite SNMPWEBCARD Device
• Search Google for Tripp Lite SNMPWEBCARD Information
• Search Photo of Tripp Lite SNMPWEBCARD in Google Images
• Search Twitter for Tripp Lite SNMPWEBCARD News