Xante Accel-a-Writer 3 Series Operation & User’s Manual

234, 8-6 Printing with Various Media Types________________________ Printing Transparencies Always use the multipurpose feeder, following the procedure in chapter 2, the media specifications in chapter 7, and these guidelines when printing transparencies. • Avoid handling transparencies excessively…

212, Xante Accel-a-Writer 3 Series 6-38 Configurationbb ______________________________________ Adjusting Print Density You can increase or decrease the amount of toner laid down by the printer using the print density dial. Note: The amount of toner used increases as printer dial settings move from low (L) to high (H). Printing with …

29, __________________________________________ Installation 2-19 3. Align the edges of the paper stack and load it into the cassette print side up, leading edge toward the back of the printer (fig. 2.24). See “Media Sources” in chapter 7 to determine whether to load media short or long edge fir…

33, __________________________________________ Installation 2-23 8. Verify that the printer’s LocalTalk interface is enabled and configured properly. See “Interface Control” in chapter 6 and “XANTÉ Command Center” in chapter 3. Before using your printer, install and configure the A…

70, 3-32 Macintosh Setupbb ____________________________________ Calibration with a Densitometer (Gamma) Densitometer support (3G) allows you to use gamma curves to adjust your printer’s performance to eliminate inconsistencies due to equipment age, different toners, press inks, and med…