TYAN S5533 Operation & User’s Manual

50, http://www.tyan.com 50 3.3.5 Onboard Device Configuration NOTE: The BIOS will automatically read the onboard LAN controller. I210 LAN1 Enable/disable Intel I210 LAN1 Port. Enabled / Disabled I210 LAN1 PXE Enable/disable I210 LAN1 PXE. Disabled / Enabled I210 LAN2 Enab…

56, http://www.tyan.com 56 3.3.8.1 Serial Port 1 Configuration Serial Port Enable or disable Serial Port (COM). Enabled / Disabled Change Settings Select an optimal setting for Super IO Device. Auto / IO=3F8h; IRQ=4; / IO=3F8h, IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; / IO=2F…

88, http://www.tyan.com 88 BIOS Temp Sensor Name Explanation: BIOS Temp Sensor Name Explanation CPU_DTS_Temp Temperature of the CPU Digital Temperature Sensor CPU_PECI_Value Temperature of the CPU Platform Environment Control Interface CPU_DIMM_A0 Temperature of DIMM1 Slot …

23, http://www.tyan.com 23 Heat sink Installation After installing the processor, you will need to proceed to install the heat sink. The CPU heat sink will ensure that the processor do not overheat and continue to operate at maximum performance for as long as you own them. An overheated proc…

61, http://www.tyan.com 61 buffers are empty, a ‘start’ signal can be sent to restart the flow. Hardware flow control uses two wires to send start/stop signal. None / Hardware RTS/CTS Data Bits / Parity / Stop Bits Read only. …

63, TYAN S5533 http://www.tyan.com 63 3.4.1 PCH-IO Configuration SLP_S4 Assertion Width Select a minimum assertion width of the SLP_S4# signal. 4-5 Seconds / 1-2 Seconds / 2-3 Seconds / 3-4 Seconds Restore AC Power Loss Specify what state to go to when power is re-applied aft…