TYAN TITAN TURBO PLUS ATX Manual 

9, TYAN TITAN TURBO PLUS ATX 9 For Resellers Only: A receipt or copy of your invoice marked with the date of purchase is required before any warranty service can be rendered. You can obtain service by calling the manufacturer for a Return Merchandise Authori- zation (RMA) number. The RMA number should be pro…

62, 62 Chapter 6 BIOS ROM checksum error-System halted The checksum of the BIOS code in the BIOS chip is incorrect, indicat- ing the BIOS code may have become corrupt. Contact your system dealer to replace the BIOS. CMOS battery failed CMOS battery is no longer functional. Contact your …

57, 57 FLASH Note: You should ALWAYS clear your CMOS after flashing a BIOS. This will clear out any stray settings from your old BIOS which may have been carried over from the flashing process. Most problems encoun- tered after flashing a BIOS will be solved by this simple procedure. To re…

33, 33 Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks. Note that the BIOS cannot distinguish between 720KB, 1.2MB, and 1.44MB drive types, as they are all 80 tracks. Disabled BIOS will not search for the type of floppy disk drive by trac…

38, 38 Chapter 4 Fast MA to RAS# delay Do not change these values unless you change the specifications of the installed DRAM or the installed CPU. SDRAM(CAS Lat/RAS-to-CAS) You can select a combination of CAS latency and RAS-to-CAS delay in HCLKs of 2/2 or 3/3. The board designer should have set the…

41, 41 Video Off After Selects the mode in which you want the monitor to blank. MODEM Use IRQ If Resume by Ring is Enabled, it is possible to wake the system by dialing in. This field determines which IRQ will be monitored for the incoming call. Doze Mode Defines the continuous idle time before the sy…