Tyco Electronics A1029 Operation & User’s Manual

42, GPS Receivers A1029-A/-C, A1029-B/-D In case the rise time of the supply voltage signal from 0V to the minimum Vcc threshold is longer than 10ms, it is recommended to implement an external reset controller. This reset controller will keep the nRST at low level as long as the con- troller…

10, Tyco Electronics A1029 GPS Receivers A1029-A/-C, A1029-B/-D 2 Ordering Information 2.1 GPS Receiver A1029-A/-C and A1029-B/-D The order numbers are built as follows: • V23993A1029Axxx • V23993A1029Bxxx • V23993A1029Cxxx • V23993A1029Dxxx V23993 stands for Tyco Electronics wireless and commu…

39, GPS Receivers A1029-A/-C, A1029-B/-D 11.4 VANT Pin (antenna voltage input pin) The VANT pin is an input pin. The supply voltage for an active GPS antenna has to be fed into the Vant pin. The easiest way to do that is to connect Vcc to VANT. The maximum current is 50mA. Note…

45, GPS Receivers A1029-A/-C, A1029-B/-D 12 Demonstration Kits 12.1 USB Kit A1029-A/-C For demonstration and easy evaluation of GPS performance Tyco Electronics offers a Demonstration Kit (including one GPS A1029-A/-C module). It contains a USB interface with according drivers to…

19, GPS Receivers A1029-A/-C, A1029-B/-D 5 Pin-out Information 5.1 Layout A1029-A/-C Figure 10: Pin-out information A1029-A/-C (top view) V4.0 – 03/07 User’s Manual Page 19 of 47 …

32, GPS Receivers A1029-A/-C, A1029-B/-D 8.2 Recommended Profile for Reflow Soldering Typical values for reflow soldering of the module in convection or IR/convection ov- ens are as follows: Peak temperature (RoHS compliant process) 245°C Average ramp up rate to Peak (183°C …