Tyco Electronics M/A-COM M-803 Operator's Manual

50, MM102014V1, Rev. G NOT flash these messages during a manual mode transition). When in the Mobile-Only operating mode, neither of these mode identifiers appears in the display. XCOV vs. XCOV-TG mode determination methods are described later. When the V-TAC goes from XCOV mode to Mobile-O…

9, MM102014V1, Rev. G 4. Do not operate the radio in explosive atmospheres (gases, dust, fumes, etc.) or near explosive blasting caps. 5. Do not attempt any unauthorized modification to the radio. Changes or modifications to the radio may cause harmful interference. Only qualified person…

53, MM102014V1, Rev. G 5.23.4 Mobile-Only Mode (“Mobile”) The Mobile-Only mode is user-selectable from the “Vmode Menu” or the radio can be configured to enter this mode automatically. When utilized, portable radios (clients) cannot connect to the V-TAC. In this mode, the V-…

61, Tyco Electronics M/A-COM M-803 MM102014V1, Rev. G 7 BASIC TROUBLESHOOTING If the radio is not operating properly, check Table 7-1 for likely causes. For additional assistance, contact a qualified service technician. Table 7-1: Basic Troubleshooting SYMPTOM CAUSE SOLUTION Radio will not turn on. No power. Test the c…

36, MM102014V1, Rev. G Table 5-1: Scan Modes SCAN MODE EXPLANATION No Scan Eliminates distractions. Full communications (transmit and receive) on selected talk group. No calls received from other talk groups. Normal (Default) The user can scan all talk groups in the active prof…

18, MM102014V1, Rev. G Icons Network Connectivity (OTP Mode) Volume Level Two Text Lines Figure 4-2: Sample Display (Talk Group Menu Session) 4.2.1 Network Connectivity Icon (OTP Mode Only) The illuminated network connectivity icon (refer to Table 4-2) indicates network conn…