SATO MB200i Manual 

13, Safety Precautions 1 13 Safety Precautions 1 12 Replacing the Battery Pack • Use only the specified battery pack. • When replacing the battery pack, make sure to install the pack with the correct direction. Incorrectly replacing the battery create the danger of injury or damage to surro…

23, Before Starting 4 23 Before Starting 4 22 • Using the AC adapter (option) to charge the battery pack The battery pack can be charged while it is mounted in the printer. • Use AC adapter Can be obtained from an authorized SATO reseller. 1 Open the cover for DC input jack and …

25, Before Starting 4 25 Before Starting 4 24 * Make sure to turn the printer power off when removing or replacing the battery. When the printer is turned off, the STATUS LED goes off. Do not remove the battery while the STATUS LED is on. Remove the battery when the STATUS LED is off.…

21, SATO MB200i Before Starting 4 21 Before Starting 4 20 1 Plug one end of the power cord to the battery charger and the other to the wall outlet. (POWER lamp lights red.) 2 Put the battery pack on the battery charger and then slide it in the direction of the arrow. Charging starts and the CHARGE lamp lights oran…

10, Safety Precautions 1 11 Safety Precautions 1 10 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including inter…

24, Before Starting 4 25 Before Starting 4 24 * Make sure to turn the printer power off when removing or replacing the battery. When the printer is turned off, the STATUS LED goes off. Do not remove the battery while the STATUS LED is on. Remove the battery when the STATUS LED is off. * If you…