Qlogic SANbox 9000 Series Interface Manual

192, 15 – Command Reference Firmware Install 15-26 59231-03 A S The following is an example of the Firmware Install command using TFTP: SANbox #> admin start SANbox (admin) #> firmware install The switch will be reset. This process will cause a disruption to I/O traffic. Cont…

33, 4 – Network and Fabric Configuration Displaying the Ethernet Network Configuration 59231-03 A 4-3 A 4.2 Displaying the Ethernet Network Configuration The Show Fabric command displays IP addresses (Enet IP Addr) for all switches in the fabric as shown in the following example. SANbox #> sho…

133, 10 – Device Security Configuration Managing Groups 59231-03 A 10-13 A 10.6.6 Modify a Group Member Modifying a group member involves changing the member attributes. The member attributes define the authentication method, encryption methods, secrets, and fabric binding, depending on the …

55, 5 – Switch Configuration Setting the Date and Time 59231-03 A 5-19 A To configure the switch to use an NTP server, enter the Set Setup System command to enable the NTP client and to specify the NTP server IP address. SANbox #> admin start SANbox (admin) #> set setup system A list…

229, Qlogic SANbox 9000 Series 15 – Command Reference Security 59231-03 A 15-63 A edit Initiates a Security Edit session in which to make changes to the security database. A Security Edit session enables you to use the Group and Securityset commands to create, add, and delete security sets, groups, and group member…

59, 5 – Switch Configuration Installing Firmware 59231-03 A 5-23 A 5.7.3 Custom Firmware Installation A custom firmware installation downloads the firmware image file from a remote host to the switch, unpacks the image file, and resets the switch in separate steps. This allows you t…