QMS 860 Operation & User’s Manual

83, Control Panel Indicators Five indicators on the control panel display printer status information: Flashes when the printer is warming up. Remains on when the printer is ready to receive a print job and during printer operation unless an error is encountered. Lights when the printer req…

165, QMS 860 Replacing the Toner Cartridge The toner cartridge lasts for approximately 6,000 prints at 4% coverage. When the toner supply is low, the printer’s message window displays TONER OUT, and usually parts of the page print lighter than normal. Sometimes you may increase the life of …

262, 4. With pin 1 (indicated by a dot in fig. 8.29) away from you, insert the 220-ohm SIP resistor pack prongs in the RN5 socket; then insert the 330-ohm SIP resistor prongs in the RN4 socket (fig. 8.29). 5. Follow the instructions in the “Replacing the Printer and Controller Board” secti…

337, divisible by 4 KB, it is automatically converted to the next lower value that is divisible by 4 KB. For example, if you enter 102 KB, the actual value is lowered to 100 KB, assuming there is enough memory available to allocate to this client. See chapter 4, the “Administration / Memory” se…

240, SELECT PASSWORD IS SELECTED Confirms and saves the se- lected password. INSTALLATION ADMIN PASSWORD Returns to Installation / Admin Password. NEXT and SELECT USE ADMIN PWD YES Advances to and selects the next Use Admin Pwd op- tion. SELECT YES IS SELECTED Confirms that the Admini- stra…

69, 1. Insert the 25-pin male printer end of the cable into the printer’s serial port (fig. 3.4); then tighten the screws on the cable to attach it to the printer. 2. Plug the other end of the cable into the host’s serial port. On some hosts, the 25-pin parallel port and the 25-pin …