Black Widow Security BW-1500 CHALLENGER PLUS Installation Manual

2, - 1 - INSTALLATION INSTRUCTIONS IMPORTANT: Make all wiring connections to the vehicle before connecting the main 14-pin connector harness to the receiver and control module. 1. Before mounting the BWS-1501 Receiver and Control Module, you must set the PROGRAMMING DIP- SWITCHES for th…

3, Black Widow Security BW-1500 CHALLENGER PLUS - 2 - 10. Complete the general wiring of the main harness by connecting... A. The RED wire to a source of CONSTANT +12vdc. IMPORTANT: Remove the 15 amp fuse from the harness before connection. B. The BLACK wire to a good chassis GROUND point. C. The WHITE wire for POSITIVE pinswitches. or... The B…

4, - 3 - CONNECTOR PIN NUMBERS AND WIRE COLOR CODES 14-PIN HARNESS # COLOR FUNCTION NOTES 1) Red +12 VDC Main Power. Connect this wire to the POSITIVE terminal of the vehicle’s battery, with the supplied fuse installed. 2) Wht/Org Parking See the wiring diagram for the proper connection of Li…

7, - 6 - TROUBLESHOOTING PROBABLE SUGGESTED SYMPTOM CAUSE CORRECTION Unit is triggered any BLUE wire is shorted to ground Disconnect the wire to see if time it is armed. or the BWS-295 or optional sensor the symptom stops. If so, check is not correctly adjusted. the wire for shorts or readju…

6, - 5 - POWER DOOR LOCK INSTRUCTIONS: The BW-1500 comes equipped to handle ground door lock installations.The Yellow and Green wires from the Receiver Module are ready to tap into grounding door lock systems. The following instructions require two SPDT Relays, not included in the BW- 1500.These Relay…