Quatech SATA2PX-100 Operation & User’s Manual

3, May/07 MN 3 Hardware Description Hardware Installation General instructions for installing the card are provided below. Since the design of system may vary, refer to your system’s reference manual for further information, if needed. …

12, Quatech SATA2PX-100 May/07 MN 12 6. Insert the floppy disk, then press Enter. 7. Select Silicon Image SiI 3132 SoftRaid 5 Controller for Windows XP/Server 2003, then press Enter. 8. Press Enter to finish driver installation, then follow the on-screen i…

10, May/07 MN 10 disk was previously part of a RAID set (or used in another system), it may have conflicting metadata. If so, this will prohibit the RAID set from being either created or rebuilt. In order for the RAID set to function properly, th…

7, May/07 MN 7 For Existing Hard Drives with Data 1. As the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS. 2. At the next screen select Create RAID Set, then press Enter. 3. At the next screen select RAID1 then pres…

14, May/07 MN 14 Windows 2000, then press Enter. 8. Press Enter again to finish driver installation, then follow the on-screen instructions to complete the Windows installation. For An Existing Installation 1. Setup the RAID Array prior to driv…

11, May/07 MN 11 BIOS Configuration The SATA2PX-100 BIOS will appear every time your system starts up. If the BIOS doesn’t show up, please try your controller in another ExpressCard slot. During this (POST) process, the BIOS will show up a…