FUTABA 7CAP Instruction Manual

80, FUTABA 7CAP OFFSET:(HELI)separate trim settings available to each idle-up setting, or assigned to separate switches from the idle-up switch. When offset is ON, movement of the trim levers adjusts the OFFSET, not the normal condition's trims ......70 Offset mix: mix that independently moves the slave ser…

79, Linear Mix: a mix that maintains the same relationship of master to slave throughout the whole range. Ex: a mix from one flap servo to another flap servo at 100% causes the 2nd servo to follow the first servo's movement exactly through all points of travel. See Programmable mix. Lithium bat…

41, FailSafe (loss of clean signal and low receiver battery) submenu (PCM mode only)(F/S ): sets responses in case of loss of signal or low Rx battery. FailSafe (F/S ): instructs a PCM receiver what to do in the event radio interference is received. Adjustability: • Each channel may be set …

15, 15 Adjusting the length of the non-slip control sticks Youmay change the length of the control sticks to make your transmitter more comfortable to hold and operate. To lengthen or shorten your transmitterís sticks, first unlock the stick tip by holding locking piece B and turning …

68, THR-CURVE and PIT-CURVE: These 5-point curves are utilized to best match the blade collective pitch to the engine RPM for consistent load on the engine. Curves are separately adjustable for normal, idle-up 1 and idle-up 2. In addition, a separate collective pitch curve is available for throttle…

37, TIMER submenu (stopwatch functions): controls an electronic clock used to keep track of time remaining in a competition time allowed, flying time on a tank of fuel, amount of time on a battery, etc. Adjustability: • Count down timer: starts from the chosen time, displays time remai…