Sekonic FLASHMATE L-308BII Operating Instructions Manual

7, 4, Light-receiving Method 4.1 Incident light metering Hold L-308BII close to the subject, point the lumisphere towards the camera, and measure the incident light intensity, (Fig. 8) ;Q,, //// II Fig . 8 Caution: Do not fit the Lumidisc next to the Lumisphere when you take incident light …

10, 6. Ambient Light Measurement 6.1 Mode Selection 0 Press the mode selector to enter the ambient light measurement mode. 0 Set up the film and shutter speeds. @ Press the measuring button, and the aperture value is displayed (Fig. 17). Fia. 17 NOTES 0 Fig. 17 shows the shutter spe…

13, ow to use the Lumidisc 9.1 How to measure light contrast @) Fit the Lumidisc on the light receiving part. See page 3 ‘3.2 How to fit the Lumidisc’. @ Select the light mode you are going to use with the mode selector. @ Hold the L-308BII close to the subject and point the Lumidisc toward t…

5, Sekonic FLASHMATE L-308BII 2. Display 2.1 LCD panel 0 Mode selection Ambient light measurement Flash measurement without cord Flash measurement with cord 0 m IS0 film speed display. See Page 6. Press the IS0 button, and m is displayed. mode symbols are switched in the following sequence: q + --da+ 8 Aperture/E…

14, 10. Specifications Type l Digital exposure meter for ambient and flash metering Light-receiving method l Incident and reflected light metering system Light-receiving section l Incident light: Lumisphere, Lumidisc l Reflected light: Lens (light receiving angle of 40°) L…