Rane SAC 23 Operator's Manual

1, Manual-1 QUICK START Whoa, hold on there. Even if you don’t read manuals as a matter of principle, at least read this section to avoid hurting yourself or your equipment. Connect the SAC 23 with the POWER off. Balanced XLR cables are recommended, but if you must convert to ¼…

2, Manual-2 MID/HIGH Frequency control is 31-position selector sets the crossover frequency between the Mid and High frequency Outputs in both channels. Consult the manufacturer of the drivers or cabinets for the correct setting. MID & HIGH LEVEL controls is controls the level of signal go…

3, Rane SAC 23 Manual-3 HIGH OUTPUTS ese are balanced Output jacks. Connect the LEFT HIGH OUTPUT to the left channel input of the high frequency am- plifier, and the RIGHT HIGH OUTPUT to the right channel input of the high frequency amplifier. When using differ- ent model amplifiers f…

4, Manual-4 Mid range Amplitude (dB) 100 Hz Filter Frequency (Hz) Low passSub High pass Low/MidMid/High Crossover Philosophy Now it gets real fun. e idea is to set the output LEVEL controls on the crossover so that the entire speaker system has a uniform, flat response. Unfortu…

5, Manual-5 Setting Levels With a Realtime Analyzer 1. Set the INPUT LEVEL as described previously on page Manual-2, and the LOW, MID, and HIGH LEVEL controls to minimum; leave the FREQUENCY controls as set previ- ously. 2. Place the analyzer microphone at least 15 feet (5 meters) away from …

6, Manual-6 ©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL 425-355-6000 FAX 425-347-7757 WEB www.rane.com 106458 APPLICATION — Active 3-Way with (or without) Mono Sub Connect as shown for a mono subwoofer. Set the SUB 100 Hz FILTER switch to the IN position…