Rane AC 22 Operator's Manual

10, Manual-10 In order to phase-align two drivers you must observe only the crossover frequency, which is common to both drivers. Pink noise can be used if all other frequencies are disre- garded, since room acoustics and imperfect driver response will cause erroneous alignment attempts. Using pin…

4, Manual-4 FRONT PANEL: MONO 3-WAY CONFIGURATION Observe the labels BELOW the controls for Mono operation.  POWER switch: Self-evident. POWER indicator: When this yellow LED is lit, the unit is ready to operate.  CH 1 MASTER LEVEL control: sets the overall level without alte…

11, Manual-11 Setting the Output Level Controls Choosing the crossover frequencies was the easy part. Now it gets real fun. The idea is to set the output LEVEL controls on the crossover so that the entire speaker system has a uniform, flat response. Unfortunately, the room in which …

1, Rane AC 22 Manual-1 AC 22 ACTIVE CROSSOVER OPERATORS MANUAL AC 22 CONNECTION Balanced/Unbalanced Inputs The ¼" Input jacks on the AC 22 are TRS (tip-ring- sleeve). We recommend connecting the AC 22 with a bal- anced cable from the balanced output of a mixer or equalizer. If a balance…

3, Manual-3 REAR PANEL: STEREO 2-WAY INSTALLATION  CHANNEL 1 INPUT: This ¼" Input accepts either balanced TRS (tip-ring-sleeve) or unbalanced TS (tip-sleeve) plugs. Use this Input only if you are running two separate Channels. For true stereo operation, connect this Input to the left cha…