Rane AC 23 Operator's Manual

10, Rane AC 23 Manual-10 OPERATING INSTRUCTIONS Selecting Crossover Frequencies Most speaker manufacturers supply low and/or high frequency cut-off points for each driver, especially if these are supplied in a system. These cut-off frequencies are based on each driver’s performance at and beyond this p…

1, Manual-1 AC 23 ACTIVE CROSSOVER OPERATORS MANUAL AC 23 CONNECTION Balanced/Unbalanced Inputs The ¼" Input jacks on the AC 23 are TRS (tip-ring- sleeve). We recommend connecting the AC 23 with a bal- anced cable from the balanced output of a mixer or equalizer. If a balanced …

8, Manual-8 REAR PANEL: MONO 4-WAY AND MONO 5-WAY INSTALLATION Observe the labels below the Inputs and Outputs for mono operation. 햲 MONO INPUT: These ¼" Inputs accept either balanced TRS (tip-ring-sleeve) or unbalanced TS (tip-sleeve) plugs. Connect the output from your mixe…

17, Manual-17 occasionally there is a need to delay the CD horn as its diaphragm is usually in front of the other drivers in the enclosure (see Fig. 5). If you are using CD horns, you should also read the CD horn EQ modification as described on page 18.With the AC 23 it is a little difficult to fig…

12, Manual-12 until the display shows +3 dB (red). The amount of displacement correction available from the Delay depends on the actual crossover frequency: the higher the frequency, the less amount of correction capability. If the drivers are built into a single cabinet and/or it is impossible to ch…

11, Manual-11 STEP BY STEP PROCEDURE A 3-Way mode consisting of High, Mid and Low drivers is used here as an example. For other configurations, use the same procedure starting with the highest crossover point and repeating steps 2 through 5 for each lower crossover point. NOTE: If you are runn…