GBC F-36 Operating And Maintenance Manual

21, F-36 PRO Laminator Operation Manual Operation © GBC Pro-Tech 1999 January 3-3 -# The footswitch on the F-36 PRO Laminator operates much like the accelerator on an automobile. When the mechanical guard is removed, use the footswitch t…

42, Maintenance and Troubleshooting F-36 PRO Laminator Operation Manual 4-8 © GBC Pro-Tech 1999 January #$7 Problem: D waves in the image, not in the laminate. Hints: • Check paper tension. • Check relative moisture cont…

31, F-36 PRO Laminator Operation Manual Operation © GBC Pro-Tech 1999 January 3-13 34*/5 "8 Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*6!575 "8 Notes…

24, Operation F-36 PRO Laminator Operation Manual 3-6 © GBC Pro-Tech 1999 January 6. Lay the image onto the adhesive side of the Falcon Board. Tacking the image down with a tacking iron at this point is sometimes helpful. 7. Push the Falcon board and image up against the leader board…

15, GBC F-36 F-36 PRO Laminator Operation Manual Installation © GBC Pro-Tech 1999 January 2-5 If the laminator is in a crate: 1. Remove the top of the crate and then the sides in the order shown in Figure 2-4. CAUTION Figure 2-4: Removing the Crate 2. Gently unwrap the shrink wrap from…