Reliance Water Heaters 184123-000 Instruction Manual

12, A gas line of sufficient size must be run to the water heater. Consult the current edition of National Fuel Gas Code ANSI Z223.1, also referred to as NFPA 54 and the gas company con- cerning pipe size. There shall be: – A readily accessible manual shut off valve in the gas supply line s…

18, 18 Due to the nature of the typical gas water heater, the water temperature in certain situations may vary up to 30°F higher or lower at the point of use such as bathtubs, showers, sink, etc. This means that when the temperature adjustment dial is set at the mark approximating 120°F, the ac…

15, Installation Checklist BEFORE LIGHTING THE PILOT: 1. Check the gas lines for leaks. a. Use a soapy water solution. DO NOT test for gas leaks using a match or open flame. b. Brush the soapy water solution on all gas pipes, joints and fittings. c. Check for bubbling soap. This means you have a …

23, Use this guide to check a “Leaking” water heater. Many suspected “Leakers” are not leaking tanks. Often the source of the water can be found and corrected. If you are not thoroughly familiar with gas codes your water heater, and safety practices, contact the gas utility to check the wat…

11, Reliance Water Heaters 184123-000 Installing the New Water Heater (cont’d) The combustion and ventilation air flow must not be obstructed. All vent gases must be completely vented to the outdoors of the structure (dwelling). Install only the draft hood provided with the new water heater and no other draft hood. The water heate…