Slant/Fin LX-90 User's Information Manual

9, Lynx 9 Mode Display Description & Temperature Display Boiler is on stand-by mode. Temperature display shows supply water Temp. Space heating mode. Temperature display shows supply water Temp. Domestic hot water mode. Temperature display shows supply waterTemp. Frost protection mod…

5, Lynx 5 Figure 5. Non-direct vent, venting through the roof. Figure 6. Non-direct vent, utilizing an existing chimney as a chase. …

7, Lynx 7 The combustion air supply must not be susceptible to contaminants, which may cause corrosion or other damage to the heat exchanger and components of the boiler, causing failure of these parts or unsafe operation. Below is a list of products which must be avoided from being stored…

11, Slant/Fin LX-90 Lynx 11 DIAGNOSTIC ERROR CODES WARNING: If an operational problem has occurred, the boiler will shut off and show an “A”, “E” or “H” in the mode display, along with an error code in the temperature display. Do not attempt performing any service under these conditions, but do note …

6, Lynx 6 2. CONDENSATE REMOVAL SYSTEM Lynx boilers are equipped with a built-in condensation drain and trap. The trap must be filled with water. DO NOT operate the boiler without filling the trap with water to prevent flue gas discharge into space. Periodic inspection should be made of this assembly …