GE Security VSR-300 Operation & User’s Manual

35, 31 Main Menu / Alarms / Email Figure 30. The email notification screen This screen allows you to setup the types of events to be notified of, and the email addresses (up to three) to be notified. Follow the context sensitive on-screen instructions to setup the individual fields. …

67, 63 To use a multicast address other than the default, uncheck Use default Multicast Address on both web pages, click the Advanced command in the mode drop-down menu and enter the same multicast address in the Streaming Address field. Figure 70. The advanced mode screen The advanced mod…

2, Copyright Copyright © 2005, GE Security Inc. All rights reserved. This document may not be copied in whole or in part, or otherwise reproduced except as specifically permitted under US copyright law, without the prior written consent from GE. Document number/revision: 0150-0285C. Disclaime…

16, GE Security VSR-300 VSR User Manual 12 Connection Diagrams Use the figures on the following pages a guide to connect the various peripherals to the VSR. Figure 5. Connection diagram 1. Microphone with amp. 2. Analog camera. 3. TCP/IP network. 4. Speakers with amp. 5. CCTV Monitor. 6. Event or alarm con…

52, VSR User Manual 48 Dynamic DNS and GnuDIP In order to use Dynamic DNS with GnuDIP, the user has to configure following in the menus: • Name Service must be set to GnuDIP (Ethernet Setting Menu). • Primary Name Server must be set to the IP address of the GnuDIP server (Ethernet Setti…

14, VSR User Manual 10 Alarm Record Reset This feature is for future development, and has not yet been implemented. Error Out The Error Out signal is activated when the unit experiences any operational or internal error. Video Loss Out The Videoloss Out signal is activated when the unit experiences vide…