Rimage Amigo II Hardware Manual

1, Producer Family™ Operator 112161_B © 2007, Rimage Corporation 1 Align the lift arm to the carousel Use this procedure to align the lift arm to the carousel in an Autostar II™, Protégé II™, Amigo II™, AutoPrinter II™, Producer 7100™, Producer 8100™, Producer 7100…

2, Align the lift arm to the carousel 2 © 2007, Rimage Corporation 112161_B 4. Place a disc on the gripper board assembly by pushing the disc into the gripper while pressing the disc release button. Release the disc release button, the gripper holds the disc. 5. Manuall…

3, Producer Family 8. If the disc is not aligned to the bins, adjust the lift arm. • To adjust the lift arm right or left: a. Remove the disc from the gripper. b. Loosen the Torx T15 screw located on the bottom of the gripper board assembly. c. Grip the disc release button and slide the…

4, Rimage Amigo II Align the lift arm to the carousel 4 © 2007, Rimage Corporation 112161_B 9. Repeat step 8 until the lift arm is aligned. - Important! Ensure that the flag is still centered in the sensor. Lift Arm Flag Lift Arm Producer II and AutoPrinter II Side of Unit Flag …

5, Producer Family Learn more Rimage Corporation reserves the right to make improvements to the equipment and software described in this document at any time without any prior notice. Rimage Corporation reserves the right to revise this publication and to make changes from time to t…