Norcross D11S Installation And Operation Manual

4, www.hawkeyeelectronics.com STEP 1 Mark & Drill the Holes 1. Find a location on the vessel that will allow clear viewing of the display. Keep in mind that the wires for the DSM must reach the mounting location of the display. 2. Lay the Display Mounting Bracket against the mountin…

17, www.hawkeyeelectronics.com • Have someone run the boat on plane for you in smooth water. CAREFULLY look over the transom at the water flowing from the bottom of the boat over the base of the transducer. The water should be "Clean" with very little turbulence (air…

22, www.hawkeyeelectronics.com 11. DO NOT proceed to the next step until you are satisfied with the readings. If you have difficulties please visit our Customer Service Center on our website or call 888- 667-2767 for technical assistance. STEP 3 Gluing the Transducer In Place …

12, Norcross D11S www.hawkeyeelectronics.com Mounting Location “DONT’s” NOTICE: To deliver consistent, accurate readings, the transducer must have a continuous supply of non- turbulent water. Do not mount the transducer in an area of turbulence or bubbles. Never install the transducer whe…

28, www.hawkeyeelectronics.com WARNING: © 2008 NorCross Marine Products Inc., All Rights Reserved. ALL unauthorized copying of the content of this document without the expressed written consent of NorCross Marine Products, Inc is strictly forbidden. NOTES …

27, www.hawkeyeelectronics.com WARRANTY This device is covered by a 2 Year Limited Warranty. To be eligible for warranty coverage, you must register your product within 15 days of purchase. Visit our website for warranty details and to register. • To Activate Your Warranty: • Read and…