Data: UPD 18th April 2024
Roland VH-12 Drums, Musical Instrument PDF Before Using (Updated: Thursday 18th of April 2024 10:23:48 PM)
Rating: 4.1 (rated by 54 users)
Compatible devices: KR-15, EXR-5, DP990F, E-60, Fa 06, KR-370, DDR-30, Pro Stand MDS-10.
Recommended Documentation:
Text Version of Roland VH-12 Drums, Musical Instrument Manual (Summary of Contents)
(Ocr-Read of Document's Main Page, UPD: 18 April 2024)
TD-20 LEAFLET
40566289 3PD
Connecting the Hi-Hat (VH-12)
and Setting the “VH Offset”
Connecting the Hi-Hat
* If you do not make VH-12’s setting correctly, it may cause
malfunction. For details, refer to the VH-12 owner’s manual.
Adjusting the Offset
When using the VH-12, the “VH Offset” needs to be set up.
1.
Loosen the clutch of the top hi-hat and let it sit
on the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
2.
Hold down [KIT] and press [TRIGGER] on the
TD-20.
The “VH offset” parameter is set automatically. (approx.
3 seconds)
[TRIGGER] stops flashing and remains lit.
fig.05-VHOffset3_70
If you need, make further adjustments to the parameters.
Refer to
Hi-Hat Settings [F3 (HI-HAT)]
(TD-20 owner’s
manual; p. 46).
* If you adjust the value of “Noise Cancel,” set it to the
minimum value required to prevent a noise.
Adjusting the Mesh Head of the
Pad (PD-125/105)
Heads MUST BE TUNED BEFORE PLAYING.
When adjusting, use a tuning key.
Like with an acoustic drum, accurate and equal head tension
is needed for correct triggering response.
* On the PD-125/105, adjusting the head tension affects only the
head response, and not the pitch of the sound, as it would on an
acoustic drum.
1.
Loosen the tuning bolts until a slight gap is
produced.
2.
Tighten all tuning bolts by fingers, as tightly as
you can.
fig.PD-Nut.e
3.
Using the tuning key, turn the tuning bolts two
full revolutions each, thus tightening them.
Tighten each tuning bolt one by one, observing the
numerical order shown in the figure.
fig.PD-BoltOrder
If You Could Not Get a Rim Shot/
Cross Stick Sound Smoothly
If you could not get a rim shot/cross stick sound smoothly,
you can adjust the parameter described below.
1.
Press [TRIGGER] - [F5 (ADVANCE)] - [F2 (RIM)]
on the TD-20.
2.
Raise the value of “RimShot Adjust.”
* Set this value as high as possible while the rim does not sound
when you hit the head strongly.
CONTROL
OUTPUT
jack
TRIGGER
OUTPUT
jack
to
TRIGGER INPUT
HI-HAT jack
to
HH CTRL jack
Clutch
screw
Compatible Memory Card
Compatible memory card with TD-20 is a 3.3 V
CompactFlash card with the capacity of 16 to 512 MB.
The other card cannot be used.
Tuning bolt
Washer
Hoop
Slight gap
13
4
2
5
6
HEAD MADE BY REMO U.S.A.
Before Playing
Recommended:
SUN ODYSSEY 42 DS, C23A750X, Sling Slingbox PRO-HD SB300-100, Phaser 200E
YoDrum G1, PED02M, Surge Cymbal Pack 1, DigiMemo L2, XD8USB
-
This manual describes the standard assembly procedure for the DTX760K/DTX920K electronic drum kits. It covers assembly and wiring of the kit as shown below.When you have completed all of the steps described, you will be ready to turn on the drum trigger module and start playing.Illustrations show th ...
Model & Doc Type: DTX920K 2
-
0102MDS-4KVXAssembly procedureParts of the TD-17KVX0304Connection procedure05For a left-handed setupAttaching the TD to a dierent locationSetup Guide© 2018 Roland CorporationIn order to use this device correctly, please carefully read “Using the Unit Safely” and “Important Notes� ...
Model & Doc Type: TD-17KVX 2
-
Alesis Pro X Hi-Hat - Frequently Asked Questions The Alesis Pro X Hi-Hat is a dual-cymbal, continuous hi-hat controller that brings natural hi-hat playability and feel to Alesis DM10 and DM8 drummers everywhere. Precisely calibrated for the Alesis DM10 and DM8 series electron ...
Model & Doc Type: PRO X HI-HAT 5
-
08795-8000 1UL Owner’s Manual fig.001e 1. Loosen the two “A” Hand Knobs and open the stand legs. 2. Loosen the one “B” Hand Knob and pull the snare pipe into position. 3. Take the Pad Mounts (C, 4 sets), Cymbal Mounts (D, 2 sets), and Sound Module Mount (E, 1 set) out of the ...
Model & Doc Type: MDS-12 4
Operating Impressions, Questions and Answers:
