Packard Bell EasyNote W Series Disassembly Manual

20, Packard Bell EasyNote W Series Packard Bell EasyNote S Disassembly Manual 19 Fig. 32 Location of screw securing the inverter board. 2. Remove the inverter board. Removing the WiFi Antenna The WiFi antenna is woven into the metal shielding in the LCD top cover. To remove the WiFi antenna, first remove the LCD panel (s…

8, Packard Bell EasyNote S Disassembly Manual 7 2. Fold the LCD completely backwards. 3. Push up the hinge/keyboard cover, which is also the keyboard cover. Use moderate force and/or use a screwdriver to lift the part on one side. 4. Fold back the hinge/keyboard cover and disconnect t…

5, 4 Packard Bell EasyNote S Disassembly Manual Removing the Battery Perform the following steps to remove the battery: 1. Make sure to power off the EasyNote S. 2. Disconnect the AC adapter (and all other peripherals) from the unit. 3. Turn the unit upside down. 4. Unlock the battery compartme…

2, 1 Packard Bell EasyNote S Disassembly Manual Table of Contents Overview 2 Technician Notes 2 Disassembly Instructions 2 Reassembly Instructions 2 Required Tools 2 Hazardous Voltage 3 Avoid Electrostatic Discharge 3 Power Supply Unit 3 Removing the Battery 4 Removing the Hard Disk Driv…

17, Packard Bell EasyNote S Disassembly Manual 16 To remove the microphone, first remove the main board (see up to step 6 in Removing the Main Board), then perform the following steps: 1. Push out the microphone from the top cover using a small flat-bladed screwdriver or tweezers. 2. Carefully …

7, Packard Bell EasyNote S Disassembly Manual 6 SO-DIMM Slot 2 To remove the memory module in SO-DIMM slot 2, first remove the WLAN adapter (see Removing the WLAN Mini-PCI Card), and then perform the following steps: 1. Removing the 3 screws securing the metal plate located beneath the mini-PCI. 2. …