Packard Bell W7 Series Disassembly Manual

5, 3 WAARSCHUWING Zorg er voor dat alle verbindingen van en naar de computer (stroom, modem, netwerk, etc) verbroken worden voordat de behuizing geopend wordt. Zet de computer nooit aan als de behuizing geopend is. AVVERTENZA Prima di rimuovere il coperchio del telaio, assicurarsi che il sis…

4, 2 Hazardous Voltage There is hazardous voltage present inside the computer when it is connected to an AC supply, even when the computer’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an Authorized Service Provider for proper (u…

13, 11 15. Remove the screws (3x D, 1xA) from the left LCD bracket. The same goes for the right bracket. Fig. 18 LCD display cable. 16. Take away the top, left and right bracket from the LCD display panel. 17. Remove the screws (2xD) holding the wireless antenna and take away the antenna.…

15, Packard Bell W7 Series 13 Bottom Base Assembly Disassemble the bottom base assembly as follows: 1. First remove the screws (4XA) from the top cover. 2. Then remove the screws (4xJ). Note: Make sure that during re-assembly the clips of the top cover lock into place before fastening the screws. 3. Turn …

17, 15 8. Take away the main board. 9. Partially remove the foil over the touchpad. 10. Disconnect the touchpad cable. 11. Remove the screws (3xB) and remove the heat plate. 12. Push out the touchpad assembly. Fig. 26 The main board and speakers. Fig. 27 The touch pad connector. Fig. 28 Removi…