Gerber enVision Owner's Manual

49, Advanced enVision Functions 45 Setting acceleration The acceleration setting represents how fast the tool head and material will get up to the speed setting. High acceleration will make the tool head and material move with quick, sudden motion. Low acceleration moves are gentl…

58, 54 enVision Owner’s Guide 6. Press F1, TEST JOBS. 7. Press F1, X08-Cut. 8. displays. Press any key. 9. displays. Press any key. 10. displays. Press F1, Start-Job. The plotter generates the X08 test pattern. If the plotter is in Single mode, as above, it will stop when …

11, Gerber enVision Getting Started 7 3. From the Devices box, click on enVision 750 or 375 to highlight it. If more than one plotter is connected to your system, highlight the enVision, then click Preferences to set the enVision as the default plotter. 4. Click on the port to which the plotter is con…

33, Choosing Tool Settings 29 If necessary, you can modify the force and corners settings right in the Settings menu. These modifications to the factory defaults will remain in effect for that material until you: manually reset the modifications to zero press default in the Settings menu to r…

39, Advanced enVision Functions 35 Send a job to the plotter and plot the job. When the job finishes, the job status displays if you are running in Single mode and if you are running in Multi mode. To repeat a job 1. Press F3 while holding down the ENTER key for the Operational Setup m…

26, 22 enVision Owner’s Guide Plotting a single job Use Single mode to plot a single job. Single mode allows you to: change material between jobs pen plot using paper before cutting vinyl reposition the start of the next job Each job plots and then waits for you to press Start-…