Giant LP200 Operating Instructions/ Repair And Service Manual

9, Giant LP200 9 To Dismantle Gear End After removing valve casing (43) and plunger pipe (29B), drain oil. Remove gear cover (4) and bearing cover (14). Loosen connecting rod screws (24A) and push the front of the connecting rod (24) forward as far as possible into the crosshead guide. IMPORTANT!…

8, 8 38 8. Remove seal case (37) from valve casing (43) and inspect o-ring (38). 9. Check plunger surface (29B). If plunger pipe is worn out, loosen tension screws (29C) and pull off plunger pipe to the front. Clean front surface of plunger (25) thoroughly. Apply a thin coat of Loctite to the…

5, 5 LP200, LP250 & LP250W-MT PARTS LIST LP200, LP250 & LP250W-MT REPAIR KITS ITEM PART DESCRIPTION QTY 1 07759 Crankcase 1 2 13000 Oil filler Plug Assy. 1 4 06085 Crankcase Cover 1 5 07104 O-ring, Crankcase Cover 1 6 07186 Oil Sight Glass 1 7 07187 Gasket for Sight Glass 1 8 06086 Oil Dipstick…

7, 7 LP200, LP250 & LP250W-MT - REPAIR INSTRUCTIONS 1. With a 30mm wrench, remove the (3) plugs (48). 2. Remove the compression spring (45) & o-rings (44A & 44B-LP250W-MT only). 3. Remove the complete valve assembly (46) with valve pullers. 44A 44B 45 4. Loosen valve seats (46A) f…

12, GIANT INDUSTRIES LIMITED WARRANTY Giant Industries, Inc. pumps and accessories are warranted by the manufacturer to be free from defects in workmanship and material as follows: 1. For portable pressure washers and car wash applications, the discharge manifolds will never fail, period. If they eve…