Gibson LPX Owner's Manual

24, Top Line (1) Tuning number (2) Modulation wet/dry mix (00-99) as selected by the blue tog-pot when switched to the Mod position (3) Compressor wet/dry mix (00-99) as selected by the red tog-pot when switched to the Comp position Middle Line (4) Tuning name (5) Delay wet/dry mix (00-99) as sel…

15, Change Pickups within Patches With Banks 1-3, the Pickup Selector/Patch Selector switch is dedicated to pickup selection; with the other Banks, the Pickup Selector/Patch Selector switch is primarily for choosing different patches within the Bank. However, although patches in Bank…

34, Gibson LPX software. Therefore, this procedure makes it difficult to restore the defaults accidentally. Note: In step 3, you will need to push the Gear Shift knob down partway—not enough to turn it off, but enough to trigger a secondary switch. This is called a “half press.” If you accident…

7, Introduction Introduction Congratulations on joining the select group of LPX visionaries. LPX co…

22, Pedalboard Display When you rotate the Gear Shift to change Banks or the Pickup Selector/Patch Selector switch to change patches, the display shows the Bank and Patch in large type for about two seconds, then reverts to the default display. The default shows the following (numbers in the de…

14, Select Sound Banks Select Sound Banks LPX has 11 Banks (1-9, A, and B), which you select with the Gear Shift knob. Each Bank has five patches (1-5), also called presets, that you select with the 5-way Pickup Selector/Patch Selector. You can freely save, load, and edit patches with the …