Global Machinery Company PEDG Instruction Manual

11, 11 Warning. The unit may become very hot during use. Avoid contact during and immediately after operation. Landscaping / trenching Before landscaping or trenching, inspect and ensure there are no exposed or buried cables or pipes or other objects that may create a hazard or interfere with…

9, 9 Starting the edger Choke control Start position (choke closed). Run position (choke open). To start the engine, proceed as follows: 1. Move the ignition switch (3) to the on position marked with an I. 2. Press the primer bulb (14) 6 times until there are no air bubbles visible …

2, 2 Contents Warranty 2 Introduction 3 Description of symbols 3 Specifications 4 Safety instructions 4 Additional safety rules for edgers 5 Contents of carton 6 Unpacking 6 Know your product 7 Assembly 8 Fueling 8 Starting the edger 9 Stoping the edger 9 Running in th…

6, 6 • Keep hands clear of edge guide and blade when cleaning as these wear to a very sharp point during edging. • Before landscaping or trenching, inspect and ensure there are no exposed or buried cables or pipes or other objects that may create a hazard or interfere with operating t…

10, 10 outwards. Rotate the knob in a clockwise direction until all of the slack is taken out of assembly. 4. Check to ensure the front wheel arm has located into one of the pre allocated positions and the head of the bolt securing the front wheel arm is sitting flat on the surface of the whee…