Grindmaster 3312 Operation & User’s Manual

10, CARE AND CLEANING Drain and Rinse (cont.) 4. Remove the carburetor tube and pour water into the storage hopper. Allow the water to fill the freezing cylinder. 5. Turn the panel switch to “CLEAN” for 5 minutes. 6. Open the dispensing valve and drain the water from the freezer. 7. Turn the freezer…

6, Page 4 Model 3312 INSTALLATION Shipment Transit 1. The freezer has been operated and tested at the factory. Upon arrival the complete freezer must be thoroughly checked for any damage which may have occurred in transit. Note: A Tip (N) Tell warning device is placed on each shippi…

9, Consistency Adjustment From time to time, it may become necessary to readjust the consistency setting (thickness) to compensate for variation between different mixes or to switch from one type of product to another. This adjustment is made as fol- lows: 1. Disconnect electrical power. 2. Rem…

11, Model 3312 Page 9 Disassembly and Cleaning (cont.) 8. Remove drip tray and empty contents. 9. Take all components to the cleaning area. 10. Prepare 1 gallon solution of hot tap water and a good grade of dishwashing detergent. 11. Thoroughly wash all components in a warm, mild detergent solution …

3, Table of Contents Safety Precautions .................................................................................................... 2 Freezer Applications & Specifications ..................................................................... 2 - 3 Installation ..............…

13, Grindmaster 3312 Clean-In-Place Procedure (Daily Cleaning) This equipment has been approved for a Clean-In-Place procedure that does not require complete disassembly on a daily basis. The unit still requires regular complete disassembly for cleaning and sanitizing. To perform the C-I-P procedure fol…