ParaBody 425 Assembly Instructions Manual

2, ! ! ! ATTENTION ! ! ! UNL ESS 0 THER WISE SHO WN, ALL CONNECTIONS WILL CONSIST OF ONE (1) BOLT, TWO C) WASHERS. (1) LOCKNUT. ONE BOLT WASHER~ CKNUT NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT. .... [//ii/i/I BOLT LENGTH BOLT LENGTH RU…

16, S]ep 1 5 A. B. @’~"-/2 X 3-1/2" /p"~ H/-’-P ~’L"~ IMPORTANT DO NOT OVERTIGHTEN 1 IN. NUTS, // Insert two 3/4 IN. FLANGE BEARINGS (9.3) into the PRESS ARM (2) as shown on the drawing. Hold the PRESS ARM (2) between the REAR and MIDDL…

28, I I I I I I_AT CABLE~,~----~-"- | | EXTENSION (6535901) ~~~ CABLE (65690(21), MULti-PRESS CABLE (6536001) Step 5 A. SECURELY affach ~he LEG CABLE to the LEG CURL/EXT (23) using one 5/8 X 1 IN. BOLT (74), ~wo .5/8 IN. WASHERS (69), and one 5//8 IN. LOCK NUT (…

12, ParaBody 425 (CONTINUED FROM PAGE 12..) C. SECURELY assemble the WEIGHT STACK SHAFT (104) fo the HEAD PLATE (105) as shown on drawing, using one 5/B X 1 IN. BUTTON HEAD CAP SCREW (78) and one 5/8 IN. BLACK LOCK WASHER (77). D. Shop two WEIGHT PLATE BUSHINGS (107) each, …

26, S|ep 4 A. To ~ssemble the PEC DEC CABLE (110), follow the cobble routing diagram on drawing, and use the following steps: ~Assemble each end of the PEC DEC CABLE (110) to the PEC CAMS (9). *~Drope the CABLE (110) over the ~PULLEYS on the CENTER PULLEY BRAC…