Paradyne Network Adapter 3510 Quick Reference Manual

18, 16 S1-4: DSR Normal during Local Loopback – DSR ON during Local Loopback. When enabled, this strap forces the DSR lead ON during a Local Loopback. This allows DTEs that rely on DSR being on to send test messages to the DSU. When disabled, DSR is turned Off during a Local Loopback. S1-…

12, 10 Table 1. Straps S1 through S5 (1 of 2) Switch Selection Position Function S1–1 S1–2 S1–3 S1–4 S1–5 S1–6 — — R F R F R F R F See Table 2, Timing Signal Source Selection See Table 2, Timing Signal Source Selection Disables circuit assurance function (Default) Enables circuit a…

22, 20 No repairs may be performed by the user. Should you experience difficulty with this equipment, refer to Warranty, Sales, Service, and Training Information inside the cover of this document. For Digital Data Service (DDS) installations, inform the local telephone company of …

7, Paradyne Network Adapter 3510 5 Installing the Rear Connector Plate To install a DSU and its rear connector plate for the first time:  Procedure 1. Configure the DSU to meet the requirements of the application (refer to Hardware Strapping on page 8). Do not disable the front panel switches at this time. 2. At the rear of …

17, 15 Table 4. Network Address Selection for Model 3510 (4 of 4) Network Address Switch S4 Selection Network Address 654321 56 F F F R R R 57 F F F R R F 58 F F F R F R 59 F F F R F F 60 F F F F R R 61 F F F F R F 62 F F F F F R 63 F F F F F R 64 (Default) R R R R R R F = Front R = R…

10, 8 Hardware Strapping Both Model 3510 and 3511 DSUs can be configured for installation at the local or remote end of a network by setting onboard straps. The straps also allow you to configure either type of DSU (Model 3510 or 3511) as a LADS for connection to 4-wire metallic circu…