Paradyne 3810 Quick Reference Manual

18, 16 AT COMMANDS (continued) \N1 Direct Mode. Modem does not use error control; DTE rate and VF rate must be the same. \N2 MNP or Disc. Modem disconnects if it does not connect in MNP mode. \N3 MNP or Buffer. Modem connects in Buffer mode if it does not connect in MNP mode. \N4 V.42/MNP or…

23, 21 4. If the modem causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you…

13, 11 Control Remote Speaker Reset Make_Busy or RemoveMakeBusy Service_Line or DiscServLine Download Code Secondary Prim (data blckd) (ExitRem appears instead of Remote when using Remote Mode) Security Set_Access_Ctrl (Admin Password?) Reset_Security EditPassWdTable Set_Answer_Sec Set_Or…

16, Paradyne 3810 14 AT COMMANDS (continued) Z3 Loads contents of Active (Saved) into Active (Operating) and performs a reset. Z9 Performs a full modem reset. &Cn LSD Control &C0 Forced On. Forces LSD ON at all times. &C1 Standard RS232. LSD is ON when the remote modem’s carrier signal is de…

8, 6 DTE Connection Use the following procedures to connect the EIA-232-D cable and ferrite choke from the modem to the DTE: 1. Make sure the modem’s rear panel power switch is Off. 2. Connect the DB-25 plug on the cable to the DB-25 socket labeled DTE on the modem’s rear panel. Use…

5, 3 Customer-Supplied Equipment The following customer-supplied equipment is required to complete a data communications system using either the Model 3810 or Model 3820 modem:  A DTE with an available EIA-232-D serial port.  A standard EIA-232-D male-to-female cable with a male DB-25-S connect…