Paradyne 5030 Installation Instructions Manual

5, Paradyne 5030 5 Installing the POTS Splitter Wiring The local loop terminates at the punchdown block or NID. Wiring must be connected from the customer premises side of the punchdown block or NID to an RJ11 jack. Typically, the punchdown block is installed in commercial locations and the NID is i…

9, 9 DSL Access Wiring " Procedure 1. Attach new wiring to the T1/R1 connectors that will go to the DSL jack from the punchdown block or NID. 2. Tighten the T1/R1 terminal screws with a flat-blade screwdriver. 99-15485-01 DSL RJ11 Jack Central Office Punchdown Block or NID Customer…

11, 11 ! Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. This product is intended to be connected to Listed/Certified telephone wiring with a minimum of 24 AWG (.5 mm) behind a Listed/Certified primary protec…

3, 97-15247 POTS Splitter Housing 3 Mounting the POTS Splitter Housing The POTS splitter can be placed: H On the outside of the building near the punchdown block or NID, or H Inside the building. When mounted outside, the POTS splitter must be installed at or above the height of the NID,…

10, 10 Hotwire 5030 POTS Splitter Technical Specifications Item Specification * Height x Width x Depth 6.65″ x 5.44″ x 2.25″ (16.89 cm x 13.82 cm x 5.72 cm) Weight 10.2 ounces (289.2 grams) Approvals FCC Part 68 Safety Certifications Refer to the equipment’s label for Registra…

6, 6 Green and Red are the standard pair wiring colors used in the next example for Tip T1 and Ring R1. Your wiring may differ. DSL/POTS From Local Loop Telephone Network Interface Device (NID) Ground Tip T1 (Green) Ring R1 (Red) 97-15502 Existing POTS Wiring to Telephone Demarcation P…