Paradyne 5920 Installation Instructions Manual

10, 10 May 2005 5920-A2-GZ40-00 Warranty, Sales, Service, and Training Information Contact your local sales representative, service representative, or distributor directly for any help needed. For additional information concerning warranty, sales, service, repair, installation, documen…

5, 5920-A2-GZ40-00 May 2005 5 Installation into a Rack with Threaded Screw Holes Procedure To install a chassis in a rack with threaded screw holes: 1. Install the mounting brackets appropriate for your rack. 1. Determine where the chassis will be placed in the rack. 2. Line up the chassis mou…

3, Paradyne 5920 5920-A2-GZ40-00 May 2005 3 5920 POTS/ISDN Splitter Chassis Installation The POTS/ISDN splitter chassis is shipped with mounting brackets that allows it to be mounted in a 19″ (483 mm) or 23″ (584 mm) cabinet or rack. Figure 1. 5920-B1-048 Set Up for a 19-Inch Rack Figure 2. 5920-B1-192…

4, 4 May 2005 5920-A2-GZ40-00 In preparation for bracket and chassis installation, determine:  Whether the equipment will be rack-mounted.  Width of the rack: 19″ (483 mm) or 23″ (584 mm).  Whether the rack has mounting rails with threaded or non-threaded screw holes. …

9, 5920-A2-GZ40-00 May 2005 9 Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product and included in this manual. 2. Use a Listed/Certified minimum 24 AWG (0.205 mm 2 ) wire for connection to the interface connectors. 3. This equ…

6, 6 May 2005 5920-A2-GZ40-00 Cabling See Cables You Need on page 2 for information about POTS splitter cabling. Procedure To cable the 5920 POTS/ISDN splitter: 1. For each card, connect the DSL interface to the DSL ports connector of your DSLAM or BLC. 2. For each card, connect the Line int…