Paradyne 5011 Installation Instructions Manual

13, 13 5020-A2-GN10-20 March 1998 Cable Installation Using Cross-Connect Block Interface connections:  DSL Interface connects to a punchdown block and cross-connects with the 8800 DSLAM LINES 1–6 cable which is also connected to a punchdown block.  LOOP Interface connects to the local loop via …

1, TM 1 5020-A2-GN10-20 March 1998 Hotwire 5020 POTS Splitter Central Office Installation Instructions Document Number 5020-A2-GN10-20 March 1998 About the Hotwire 5020 RADSL POTS Splitter The Hotwire RADSL System enables simultaneous high-speed digital data access and analog vo…

12, 12 5020-A2-GN10-20 March 1998 Cabling Examples To connect 24 pairs from two POTS splitter cards to the DSLAM, use a Y-cable. The DSLAM connector feeds 24 DSL ports, comprised of six slots with four ports per DSL card slot. Interface connections:  DSL Interface connects to the 8800…

14, 14 5020-A2-GN10-20 March 1998  Procedure To install the Y-cable: 1. Connect the cable head labeled P2 To 1–12 to the second POTS splitter shelf. P1 P2 To 1-12 To P1 Pairs 1 to 12 To P1 Pairs 13 to 24 Captive Screw Captive Screw Captive Screw 97-1580 6 P3 To 13-24 Y-Cable 2…

19, Paradyne 5011 19 5020-A2-GN10-20 March 1998 Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product and included in this manual. 2. Use a Listed/Certified minimum No. 24 AWG wire for connection to the interface connectors. 3. This equipment is to be con…

8, 8 5020-A2-GN10-20 March 1998 3. Use a Phillips screwdriver to install the: — Single-card chassis in 19″ or 23″ rack, or a six-card chassis in a 19″ rack. — Six-card chassis in a 23″ rack. Install the top two screws loosely enough to allow the bracket’s upper keyholes to d…