Parvus SpacePC 1232 Series Operation & User’s Manual

69, 69 69 Watchdog time-out pin For external control purposes, the status of the watchdog time-out event is provided to connector J11 pin 9. This signal goes high when the watchdog resets the system. The software can reset this signal by setting and resetting bit 2 of the I/O port …

47, Parvus SpacePC 1232 Series 47 47 1 MB 1 Megabyte reserved for Video Memory 2 MB 2 Megabyte reserved for Video Memory 4 MB (*) 4 Megabyte reserved for Video Memory (*) = Default setting Network Adapter The user can manually enables or disables the on-board network adapter. Option Descri…

13, 13 Chapter 3 Connectors Description This chapter provides a brief description of the SpacePC 1232 module’s connectors, with their positions and functions. Connectors Layout In the following figure are shown the connectors with their layout and function/s. J10 AC97 Audio Serial…

49, 49 49 Serial Ports 1 and 2 The number of serial ports is two. The Serial Port Mode is selectable (RS232, RS 422 and RS 485), like the IRQ number. Serial Port1 (J5) The user according the device connected to the interface can choose The Serial Port1 Mode. The default mod…

31, 31 31 J10 VGA Connector The J10 is a 5x2 pin connector with step =2.54 mm. J10 VGA Figure 17. J10 Connector layout Refer to the following table for the VGA connector assignment. Table 15. J10 VGA Connector Pin Signal Function 1 VSYNC Vertical synchronizat…

2, 2 ABOUT THIS MANUAL This manual is meant for engineers and programmers who wish to use the Parvus SpacePC® 1232. It contains technical specifications, and describes the connectors and how to properly use and configure the product. NOTICE Although all the information contained h…