Pass Laboratories Aleph P Owner's Manual

7, Pass Laboratories Aleph P 2) The characteristic of gain devices and their specific use is important. Individual variations in performance between like devices is important, as are differences in topological usage. All signal bearing devices contribute to the degradation, but there are some different ch…

3, Setup The preamplifier has four sets of input connections, two sets of output connections, an input selector and three level controls. Optionally, it also has a remote control. It also has an AC line power connection. The amplifier's voltage and current rating are indicated on the rear.…

5, If you have a concern that the output impedance may be too high to properly drive the capacitance of a cable, keep in mind that that 1000 ohms still will allow bandwidth to 160 kHz into 1000 pF of capacitance. The maximum output impedance only occurs at the volume control maximum, and quickly…

6, nested feedback, no feedback, feed forward, Stasis, harmonic time alignment, high slew, Class AB, Class A, Pure Class A, Class AA, Class A/AB, Class D, Class H, Constant bias, dynamic bias, optical bias, Real Life Bias, Sustained Plateau Bias, big supplies, smart supplies, regulat…

10, SPECIFICATIONS Gain 15 dB bal in / bal out 15 dB unbal in / bal out 9 dB bal in / unbal out 9 dB unbal in / unbal out Freq. Response -3 dB @ 5 Hz -3 dB at > 100 kHz Distortion < .1 % THD typically .01% @ 2 volts @ 1KHZ Maximum Output 15 volts rms. bal out 8 volts rms. unbal out Ou…

8, Triodes and Mosfets share a useful characteristic: their transconductance tends to increase with current. Bipolar power devices have a slight gain increase until they hit about an amp or so, and then they decline at higher currents. In general the use of bipolar in a single ended Class A circui…