Patton electronics SmartWare R.3.20 Software Configuration Manual

322, 322 Chapter 27 CS interface configuration Chapter contents Introduction........................................................................................................................................................324 CS interface configuration task list ................................…

545, Debugging call signaling 545 SmartWare Software Configuration Guide 42 • VoIP debugging 01:00:10 H323 > [EP h323-00c07230] Destination Address: TEL:60,60 01:00:10 H323 > [EP h323-00c07230] Source Address: TEL:50,50 01:00:10 H323 > [EP h323-00c07230] P…

419, Call router configuration task list 419 SmartWare Software Configuration Guide 33 • Call router configuration The following table shows the different digit-collection timeout configurations and their effect on a T-termi- nated route when the digit-collection timeout elapses. Im…

239, SNTP client configuration task list 239 SmartWare Software Configuration Guide 20 • SNTP client configuration Enabling and disabling the SNTP client The SNTP client is disabled by default and has to be enabled if clock synchronization shall be used. This pro- cedure describes how …

550, Debugging voice data 550 SmartWare Software Configuration Guide 42 • VoIP debugging Depending on the type of problem, some debug monitors are more useful than others. Try to avoid enabling all monitors at the same time, as this generates a lot of output and can degrade system p…

203, Patton electronics SmartWare R.3.20 RIP configuration task list 203 SmartWare Software Configuration Guide 17 • RIP configuration Mode: Interface Example: Specifying the default route metric The following example shows how to set the routing metric to 4 on IP interface wan. node(cfg)#context ip router node(ctx-ip)[router]#i…