Patton electronics SmartNode 4650 Getting Started Manual

32, 32 Chapter 4 Initial configuration Chapter contents Introduction..........................................................................................................................................................33 1. Connecting the SmartNode to your laptop PC......................…

24, Planning the installation 24 SmartNode 4650 Getting Started Guide 3 • SmartNode installation Planning the installation Before installing the ISDN IAD device, the following tasks should be completed: • Create a network diagram (see section “Network information” on page 24) •…

42, Patton electronics SmartNode 4650 Introduction 42 SmartNode 4650 Getting Started Guide 5 • DSL Basic Configuration Introduction The SN4650 model has an option for a built-in G.SHDSL or ADSL modem. The modem appears in the con- figuration as "port dsl 0 0" mode. Figure 12. Configuring the G.SHDSL card for …

14, 14 Chapter 1 General information Chapter contents SmartNode 4650 overview ....................................................................................................................................15 SmartNode 4650 rear panel .....................................................…

28, Installing the gateway router 28 SmartNode 4650 Getting Started Guide 3 • SmartNode installation The SN4650’s V.35 interface is wired as a DTE. No DCE configuration is possible. If you are directly connect- ing the SN4650’s V.35 interface to third-party equipment that cannot be config…

34, 2. Configuring the desired IP address 34 SmartNode 4650 Getting Started Guide 4 • Initial configuration SmartNode will provide the PC with an IP address. You can check the connection to the SmartNode by exe- cuting the ping command from the PC command window as follows: ping 192.168.1.1 2.…