Patton electronics 1094 Operation & User’s Manual

7, 11 12 4.2.2 CONNECTION TO A “DTE” DEVICE The serial port on most QuickConnect™ interface modules (all except the X.21 module) is hard-wired as a DCE. Therefore these modules “want” to plug into a DTE such as a terminal, PC or host. When making the connection to your DTE device, use a …

6, 9 10 When connecting two Model 1094’s, it is necessary to use a crossover cable. The diagram below shows how a crossover cable should be constructed. RJ-45 Cable (4-Wire) SIGNAL PIN# PIN# SIGNAL XMT+ 1-----------------------8 RCV- XMT- 2-----------------------7 RCV+ GND* 4--------------…

1, USER MANUAL MODEL 1094 KiloModem-768 TM High Speed Baseband Modem SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007 http://www.patton.com Part# 07M1094-C Doc# 032031UC R evised 04/13/99 CERTIFIED An ISO-9001 Certified Company …

8, 13 14 5.0 OPERATION Once the Model 1094 is properly configured and installed, it should operate transparently. This sections describes power-up, read- ing the LED status monitors, and using the built-in loopback test modes. 5.1 POWER-UP Before applying power to the Model 1094, …

13, Patton electronics 1094 23 APPENDIX D PATTON ELECTRONICS MODEL 1094 INTERFACE PIN ASSIGNMENT (Continued) X.21 Interface (DB-15 Female Connector) (DTE /DCE Configuration) Pin # Signal 1. . . . . . . . . . . . Frame Ground 2. . . . . . . . . . . . T (Transmit Data-A) 3. . . . . . . . . . . . C (Control-A) 4. . . . .…

2, 1 2 1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1094 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment. This warranty is limited to defects in workmanship or materials, and…