Westpoint WI-0035 Operation & User’s Manual

8, Troubleshooting 1. PROBLEM: a. If the Heat Emitter is broken or damaged b. If the Control Panel is not responding, the temperature reading is above 86 0 F/30 0 C, or there is a burning odor coming from the portable heater c. Or if the power cord is damaged SOLUTION: Contact the manuf…

6, Westpoint WI-0035 4) Again, the default set temperature displayed on the LED display is 72 0 F. By pressing the TEMP button, the LED display will switch to the temperature status and flash. You must press the HI/LOW/UP button or 0 C/ 0 F/DOWN button once again within (5) seconds to set th…

7, your room is that cooler or that the heater is not heating. If your heater’s display and your external temperature read-out mechanism (thermometer, wall thermostat, etc.) are within a 5 to 6 degree difference, it is completely normal. Recommendations for Maximum Perfo…

4, B. An AC Cross Flow Fan pushes air over these Infrared Quartz Bulbs. Cross Flow Fans create a wide flow of air using a cylindrical-shaped impeller. Air is drawn inside the Infrared Heater, flows along the circumference of the chamber and over the Infrared Quartz Bulbs, and is blown o…

5, Adjust TIME / TEMP with down arrow or adjust 0 C/ 0 F settings. 1) Plug the power cord directly into a conventional 120V 15 amp outlet and press the MASTER POWER switch on the rear of the portable heater. Then press the POWER button on the front control panel or on…