Hand Held Products 3800E Operation & User’s Manual

24, 1 - 12 IMAGETEAM™ 3800E User’s Guide RS-232 Word Length: Data Bits, Stop Bits, and Parity (continued) 8 Data, 1 Stop, Parity None 7 Data, 2 Stop, Parity Space 8 Data, 1 Stop, Parity Even 8 Data, 1 Stop, Parity Odd 8 Data, 1 Stop, Parity Mark 8 Data, 1 Stop, Parity Space …

67, IMAGETEAM™ 3800E User’s Guide 5 - 17 Code 11, continued Message Length The message length selection is used to set the valid reading length of the bar code. If the data length of the scanned bar code doesn’t match the valid reading length, the scanner will issue an error beep. You may…

27, IMAGETEAM™ 3800E User’s Guide 1 - 15 Wand Emulation Idle The idle describes the state of the scanner when no data is being transmitted. When in Wand Emulation mode, you must set the scanner’s idle state to match the idle state for the device to which the scanner is connected. Default …

60, Hand Held Products 3800E 5 - 10 IMAGETEAM™ 3800E User’s Guide Interleaved 2 of 5 < Default All Interleaved 2 of 5 Settings > Interleaved 2 of 5 Check Digit No Check Digit indicates that the scanner reads and transmits bar code data with or without a check digit. When Check Digit is set to Validate, but Don�…

29, IMAGETEAM™ 3800E User’s Guide 2 - 1 2 Output Scan Rate Adjusting the scan rate changes the current draw when scanning. The slower the scan rate, the lower the current draw. (The standby current remains the same.) Default = 270 s/s. Note: The chart below applies to the -12 model…

56, 5 - 6 IMAGETEAM™ 3800E User’s Guide Code 39, continued Check Character No Check Character indicates that the scanner reads and transmits bar code data with or without a check character. When Check Character is set to Validate, but Don’t Transmit, the unit will only read Code 39 bar…