Hand Held Products 3060 Operation & User’s Manual

2, Disclaimer Hand Held Products, Inc. d/b/a HHP (“HHP”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should, in all cases, consult HHP to determine whether any such changes have been mad…

16, Programming the Scanner 3-2 While you are asking HHP SET to do the “Download,” “Upload,” and “Diagnostic” with the scanner, HHP SET will ask you to use the scanner to scan the Host Link Command for initial handshaking with HHP SET and then perform your desired action. H…

56, Limited Warranty 5-1 5. Limited Warranty Hand Held Products, Inc., d/b/a HHP (“HHP”) warrants its products to be free from defects in materials and workmanship and to conform to HHP’s published specifications applicable to the products purchased at the time of shipment. This warranty…

38, Programming the Scanner 3-24 Serial Interface Control ♦ Record Suffix, Handshaking & Time Out Setting ♦ PROGRAM END(Exit) Family Code Selection Parameter Selection Option Code STX/ETX Control Disable STX/ETX transmission  Enable STX/ETX transmission STX/…

41, Programming the Scanner 3-27 Trigger Modes This section allows the user to select the trigger mode that is different from the Trigger Mode default. The operations of each trigger mode are described as below. Low Power Mode When this operation mode is selected, the scanner goes i…

33, Hand Held Products 3060 Programming the Scanner 3-19 Symbology Programming ♦ MSI/Plessey, Code 128 & UCC/EAN 128 Setting ♦ PROGRAM END(Exit) Family Code Selection Parameter Selection Option Code MSI/Plessey Settings Select MOD 10 check digit  Select MOD 10-10 check digit Select MOD …