Hand Held Products IT3800 Operation & User’s Manual

16, 1 - 4 IT3800/3900 User’s Guide Connecting the Scanner When Powered by Host (Keyboard Wedge) A scanner can be connected between the keyboard and PC as a “keyboard wedge,” plugged into the serial port, or connected to a portable data terminal in wand emulation or non decoded output mode…

42, 2 - 16 IT3800/3900 User’s Guide Overall Checksum When this option is turned on, a computed check character is added at the end of the entire message. The check character is the character which when Exclusive-OR’d with every preceding character of the message yields a result of …

133, IT3800/3900 User’s Guide 12 - 7 Wand Emulation Idle Idle Low WNDIDL0 2-14 *Idle High WNDIDL1 2-14 PDF417 Wand Emulation Data Block Size 20 WNDBLK0 2-15 40 WNDBLK1 2-15 *60 WNDBLK2 2-15 80 WNDBLK3 2-15 Delay Between Blocks 5ms WNDDLY0 2-15 *50ms WNDDLY1 2-15 150ms WNDDLY2 2-15 500ms WNDDLY…

107, IT3800/3900 User’s Guide 7 - 39 China Post Code <Default All China Post Code Settings> China Post Code China Post Message Length Note: Scan the bar codes below to change the message length. Refer to Message Length Description (page 7-2) for additional information. Minimum and Maximu…

8, iv Code 39................................................................................. 7-6 Start/Stop Characters..................................................... 7-6 Check Character............................................................. 7-7 Code 39 Message Length....…

45, Hand Held Products IT3800 IT3800/3900 User’s Guide 3 - 3 Reread Delay This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads at POS (p…