Pella V981553 Installation Instructions Manual

3, Pella V981553 2 PREPARE THE DOOR FOR INSTALLATION A. Remove the packaging from the door. Inspect the frame and sash for damage. DO NOT install damaged units. Note: If screens or hardware are removed from the door at this time, label them and store them in a protected area. TWO OR MORE PEOPLE WILL BE R…

5, C. Identify the keeper in the hardware package and perform the keeper attachment steps based on which keeper is in the package. Determine the keeper location by opening the panel a few inches, and extending the lock hook. With a pencil, mark the location on the jamb dir…

6, Note: When applying siding, brick veneer or other exterior finish materials, leave adequate space between the door frame and the material for sealant. Refer to the illustration that corresponds to your finish material. Not allowing adequate space or not using backer rod may c…

8, G. To snap the sill track in, place an 8" long 2" x 4" block on edge and begin tapping it from one end with a rubber mallet until the track snaps into its original position. INSTRUCTIONS (REVERSING DOOR SLIDE) Note: Doors with Blinds-Between-the-Glass are not reversible. F. Go to s…

7, INSTALLATION INSTRUCTIONS (BOTTOM FIN REMOVAL) A. To remove the bottom fin, lay the door down with the interior facing up. With a utility knife, carefully score the entire length of the fin three times where it meets the sill. Bend the fin back and forth a few times, then p…

1, INSTALLATION INSTRUCTION - INSTRUCCIONES DE INSTALACION FOR SLIDING PATIO DOOR Installation Instructions for Typical Wood Frame Construction. These instructions were developed and tested for use with typical wood frame wall construction in a wall system designed to manage water. These inst…