Pella 80ED0101 Installation Instructions Manual

6, 6 INTEGRATING THE WINDOW TO THE WATER RESISTIVE BARRIER Note: The flashing tape must be applied approximately 1/2" onto the frame cladding at the jambs and head. Pre-folding the tape at 1/2" before removing the paper backing will make it easier to apply the tape corr…

1, INSTALLATION INSTRUCTIONS - INSTRUCCIONES DE INSTALACION FOR HURRICANESHIELD ® IMPACT-RESISTANT DOUBLE-HUNG, SINGLE-HUNG AND SIMULATED-HUNG Part Number: 80ED0101 ©2008 Pella Corporation Instrucciones en español en el reverso. Fin Corner Nailing Fin Window Bottom Sill Flash…

2, Pella 80ED0101 REMEMBER TO USE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT. 1 ROUGH OPENING PREPARATION A. Verify the opening is plumb and level. Note: It is critical that the bottom is level. B. Verify the window will fit the opening. Measure all four sides of the opening to make sure it is…

4, 4 INSTALLATION CLIP METHOD A. Fasten the window to the openingBYDRIVINGTWO XCORROSION resistant screws into the pre-punched holes in the clips. If clips are bent and fastened to the interior stud/block, install the screws as close to the bend as po…

7, C. Fold down top flap of water resistive barrier (6C). D. Apply flashing tape to diagonal cuts. Cut pieces of flashing tape at least 1" longer than the diagonal cuts in the water resistive barrier. Apply the tape covering the entire diagonal cut in the water resistive barrier at both u…

3, 2 PREPARE THE WINDOW A. Remove plastic wrap and cardboard packaging from window. DO NOT cut the checkrail bands or remove plastic shipping spacers located between the window sash and frame. The shipping spacers will help keep the window square during installation. DO NOT open the window unti…