Pella 80GY0102 Installation Instructions Manual

2, A. Verify the opening is plumb and level. Note: It is critical that the bottom is level. 1 ROUGH OPENING PREPARATION REMEMBER TO USE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT. B. Verify the window will fit the opening. Measure all four sides of the opening to make sure it is 1/2&qu…

5, Pella 80GY0102 3 SETTING AND FASTENING THE WINDOW TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS. " *OUFSJPS # # & A. Insert the window from the exterior of the building. Place the bottom of the window on the spacers at the bottom of the opening, then tilt the top int…

6, A. Apply side flashing tape. Cut two pieces of flashing tape 5" longer than the frame height of the window. Apply the tape 1/2" onto the frame cladding, over the fin and laps onto the water resistive barrier. The tape should extend 2" above the top of the w…

4, B. Windows using Frame Screws: On the roomside of vent windows, drill 13/64" diameter clearance holes through the head, jambs and sill of the frame. Space the holes using the maximum end and on center spacings as shown on the placement diagram. Note: On vent casements, place the …

9, INTERIOR FINISHING If products cannot be finished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any construction residue before finishing. Sand all wood surfaces lightly with 180 grit or finer sandpaper. DO NOT use steel wool. BE CAREFUL NOT TO…